Skip to content

Electrical Testers

Testers for electrical installations, motors, transformers and batteries: insulation, earth, RCD, loop, resistance and safety testing, plus everyday multimeters and clamp meters.

All products in Electrical Testers

Kusam Meco 273HP Non-Contact Voltage Detector, 50 V to 132 kV

Compact non-contact voltage detector with LOW (50 V – 1.5 kV) and HIGH (1.5 kV – 132 kV) ranges, bright LED and audible alarm, zero power drain when off. Use on a hot stick for high voltages.

Enquire about Kusam Meco 273HP
HTC Instruments 21S Smart AC/DC Clamp Meter

Smart true RMS AC/DC clamp meter, 600 A, with colour display, 5,999 counts, auto mode, NCV, live-wire detection, capacitance, frequency/duty cycle and temperature. CAT III 600 V.

Enquire about HTC Instruments 21S
CIE CIE-PSI-2 Phase Sequence Indicator, Panel Mounted 96 x 96 mm

Panel-mounted 96 x 96 mm phase sequence indicator with a rotating disc, for 100-500 V AC mounted vertically or 50-500 V AC horizontally, 25 to 60 Hz, rated 30 seconds at 500 V. No auxiliary supply needed.

Enquire about CIE CIE-PSI-2
Fluke 15B MAX-01 Digital Multimeter with TL75 Test Leads

6000-count digital multimeter with input alert alarm, supplied with TL75 test leads; 1000 V, 10 A, CAT III 600 V.

Enquire about Fluke 15B MAX-01
Meco 36-AUTO BL 3 5/6-Digit 600 A AC/DC Digital Clamp Meter with Temperature and Frequency, TRMS

TRMS 6000-count AC/DC clamp meter: 600 A AC/DC, 600 V AC/DC, 60 mF, 60 MΩ, frequency to 1 MHz, temperature and NCV; 25 mm jaw.

Enquire about Meco 36-AUTO BL
Hioki 3280-10F AC Clamp Meter

Compact average-rectifying AC clamp meter for up to 1000 A AC, with AC/DC voltage to 600 V, resistance and continuity; -25°C to 65°C operation and a 1 m drop-proof design.

Enquire about Hioki 3280-10F
Kyoritsu KEW 1019R Digital Multimeter, True RMS

True RMS digital multimeter with a large display, fuseless electronic protection on ohm and continuity ranges and a hard case. Rated CAT III 300 V / CAT II 600 V.

Enquire about Kyoritsu KEW 1019R
Waco AET 0-2-10 Analogue Earth Tester 0-2-10 Ω, Dual Range, 4 Terminal, Hand Driven

Hand-cranked analogue 4-terminal earth tester from Waco, dual range 0-2-10 Ω, for earth electrode resistance and soil resistivity checks on site, with no batteries to run down.

Enquire about Waco AET 0-2-10
Metrel MD 9010 Autocheck Digital Multimeter

Pocket-size 6000-count autocheck multimeter: AC / DC voltage to 600 V, µA current, resistance, capacitance, frequency, diode, continuity and non-contact electric field detection; 78 g, CAT III 300 V.

Enquire about Metrel MD 9010
Lutron CA-203 DC/AC Current Clamp Adapter, 2000 A

Hall effect clamp adapter for AC and DC current up to 2000 A with an 86 mm jaw, giving a voltage output for reading on a multimeter.

Enquire about Lutron CA-203
Rishabh 615 Digital Multimeter, 6600 Count

Digital multimeter to 1000 V and 10 A with capacitance to 40 mF, frequency to 10 MHz, duty cycle, K-type temperature and peak hold; 1000 V CAT III / 600 V CAT IV.

Enquire about Rishabh 615
SEW 278 HP Non-Contact High Voltage Detector

Waterproof (IP66) non-contact high-voltage detector with 8 settings from 240 V to 275 kV, three LEDs for 360° viewing under a long hood, buzzer and self-test. Supplied with disconnect hook, fuse puller head and case.

Enquire about SEW 278 HP
Motwane I-12 1 kV Digital Insulation Resistance Tester

Compact hand-held 1 kV insulation tester for LV maintenance: 50 V to 1000 V tests, 10 kΩ to 2 GΩ, low-ohm and 100 mA continuity, AC/DC voltage to 600 V and a go/no-go limit. Battery or mains eliminator.

Enquire about Motwane I-12
Megger MIT515 5 kV Insulation Resistance Tester

Compact 5 kV DC insulation tester measuring up to 10 TΩ with IR, timed IR, DAR, PI and PI Predictor, 3 mA output, mains or Li-ion battery power and CAT IV 600 V safety; no memory.

Enquire about Megger MIT515
MCM Instruments EMC-28N Digital Motor Checker with Stethoscope

Digital motor checker with a built-in electronic stethoscope: insulation resistance to 200 MΩ at 500 V DC, low winding resistance, inductance and rotor bar checks, plus listening for bearing, gear and pump noise.

Enquire about MCM Instruments EMC-28N
Shanti ITIP Series Hand Driven Low Voltage Insulation Tester, Polycarbonate Body

Hand-cranked analog insulation tester for motors, transformers, generators, switchgear, cables and appliances: 100 V to 1000 V test voltage, ranges 0-20 MΩ to 0-2000 MΩ; to IS 2992.

Enquire about Shanti ITIP Series
Trustware Technologies WRITE-101 Winding Resistance Meter (Winding Resistance Intelligent Test Equipment)

Single-channel winding resistance meter for transformers and motors: 1 A to 10 mA test currents, 20 mΩ to 2 kΩ ranges, class 0.1, jumbo LED display, PC reports.

Enquire about Trustware Technologies WRITE-101
Kusam Meco 275HP High Voltage Proximity Detector up to 275 kV

Non-contact high voltage proximity detector with 8 voltage settings from 240 V to 275 kV AC, bright LED and sound indication, self test; fits most link sticks; IP65.

Enquire about Kusam Meco 275HP
HTC Instruments 1080PV Solar MPPT Meter

Solar MPPT meter for PV panels: maximum power 5 – 800 W, open-circuit voltage 12 – 60 V and short-circuit current 0 – 35 A in one test. Powered by the panel; auto and manual modes.

Enquire about HTC Instruments 1080PV
CIE CIE-RTS-5 Relay Test Set, Secondary Current Injection, 400 VA

Portable secondary injection set for protection relays: continuously variable current up to 200 A for short periods (0-1 A to 0-100 A ranges), 0-230 V AC output, fixed 50 V and 110 V, digital meters and timer.

Enquire about CIE CIE-RTS-5
Fluke 15B MAX-02 Digital Multimeter with TL31 Extra-Slim Test Leads

6000-count digital multimeter with input alert alarm, supplied with TL31 extra-slim test leads for circuit boards; CAT III 600 V.

Enquire about Fluke 15B MAX-02
Meco 45CF+ 4-Digit TRMS Manual Ranging Digital Multimeter

9999-count TRMS manual-ranging DMM with dual display and bargraph: 999.9 V DC, 750 V AC, 9.999 A, 99.99 MΩ, LoZ, temperature, hFE and NCV.

Enquire about Meco 45CF+
Hioki 3280-70F AC Clamp Meter with Flexible Current Sensor

Compact average-rectifying AC clamp meter for up to 1000 A AC, with AC/DC voltage to 600 V, resistance and continuity; -25°C to 65°C operation and a 1 m drop-proof design. Kit with the CT6280 AC flexible current sensor (up to 4199 A in thick or paired wires) and carrying case C0205.

Enquire about Hioki 3280-70F
Kyoritsu KEW 1020R Digital Multimeter, True RMS, 6000 Count

Rugged True RMS digital multimeter with a 6000-count backlit display, MIN / MAX and a clamp sensor mode. Rated CAT IV 300 V / CAT III 600 V / CAT II 1000 V.

Enquire about Kyoritsu KEW 1020R

Show more products