Scope T&M
55 Scope T&M products listed. For prices and availability, send an enquiry.
Scope T&M and its logo are trademarks of their owner, shown here to identify the products. Trademarks & disclaimer
SCOPE T&M, Mumbai (since 1988): test and measurement instruments for EHV and UHV substations - circuit breaker analysers, contact and winding resistance meters, turns ratio meters, cable fault locators, insulation and earth testers.
Products
-
3i Portable Partial Discharge Detector
Portable multipurpose partial discharge detector with built-in acoustic and TEV sensors for online insulation monitoring of switchgear, cables, GIS and transformers.
-
AR700 Acoustic Partial Discharge Locator
Portable acoustic partial discharge locator using magnetically mounted sensors on energised tanks to pinpoint insulation defects in transformers, CTs, GIS and cables.
-
BLUe Battery Loading Unit
Portable battery loading unit for controlled, monitored discharge tests of battery banks, with optional wireless cell monitor and PC reporting software.
-
CB SCOPE Loco Vacuum Circuit Breaker Test System
Portable analyser for the dynamic performance of loco vacuum circuit breakers (VCBs): timing, bounce, travel and coil current, controlled from a laptop over Ethernet.
-
CFL AG2 Cable Route Tracing Audio Frequency Generator
Portable audio frequency generator for tracing underground cable routes, up to 20 W, 1 kHz sine wave with automatic load matching.
-
CFL CIS Cable Identification System
Identifies the dead cable in a bundle in a trench, pit or cable rack to avoid cutting the wrong line; transmitter and flexible-clamp receiver.
-
CFL PL2+ Cable Fault Pre-Locator, 50 km
Portable cable fault pre-locator identifying fault type and distance up to 50 km, 100 MHz sampling, IP67 moulded case, mains or battery.
-
CFL PL3 Cable Fault Pre-Locator, 16 km
Cable fault pre-locator estimating the distance to underground cable faults up to 16 km, with RS-232 PC and printer connection and 50-waveform memory.
-
CFL PL3+ Cable Fault Pre-Locator, 128 km
Portable cable fault pre-locator up to 128 km with three TDR channels for three-phase cables, 5.7 inch colour display and 300-waveform memory.
-
CFL PL4+ Cable Fault Pre-Locator, 256 km
Portable cable fault pre-locator with 800 MHz sampling and 10.4 inch colour display, measuring up to 256 km with accuracy down to 0.025%.
-
CFL PP3+ Cable Fault Pin Pointer and Route Tracer Receiver
Receiver for pinpointing underground cable faults and tracing cable routes with SCOPE surge and audio generators, 5.7 inch colour touch screen, 10 hour battery.
-
CFL SG 0810 Surge Generator, 8 kV, 1000 J
Surge generator delivering 8 kV and 1000 J surges for locating faults on LV to MV underground power cables, with prelocator and pinpointer.
-
CFL SG 1610 Surge Generator, 16 kV, 1000 J
Surge generator for underground cable fault location, up to 16 kV and 1000 J, working with a prelocator, SIM filter and pinpointer set.
-
CFL SG 3210 Surge Generator, 32 kV, 1000 J
Surge generator for underground cable fault location, up to 32 kV and 1000 J, for cables from LV to EHV; the core of the SCOPE CFL system.
-
CFL SG 3220 Surge Generator, 32 kV, 2000 J
Portable surge generator for underground cable fault location, up to 32 kV and 2000 J, for cables from LV to EHV; works with SCOPE prelocators and pinpointers.
-
CFL SIMF+ Secondary Impulse (SIM) Filter
Passive secondary impulse filter that converts high-resistance cable faults into arcing, low-resistance ones so a pre-locator can find them, up to 35 kV DC.
-
CRM 100B Contact Resistance Meter, 100 A
Contact resistance meter reading micro-ohms directly at 100 A DC, battery or mains operated, designed for live EHV switchyards up to 765 kV.
-
CRM 100B+ Contact Resistance Meter, 100 A
Lightweight 100 A DC micro-ohm contact resistance meter for MV, HV and EHV equipment, with printer, memory and mains or battery operation.
-
CRM 100C Continuous Current Contact Resistance Meter, 100 A
Continuous-current contact resistance meter with selectable 10, 20, 50 and 100 A DC, reading directly in noisy live EHV switchyards.
-
CRM 100C+ Continuous Current Contact Resistance Meter, 100 A
Moulded-case contact resistance meter with built-in printer, selectable 10, 20, 50 and 100 A DC continuous current, for live EHV switchyards.
-
CRM 200B Contact Resistance Meter, 200 A
Portable 200 A DC contact resistance meter for breakers, isolators and busbar joints in live EHV switchyards up to 765 kV, battery or mains operated.
-
CRM 200B+ Contact Resistance Meter, 200 A
Lightweight 200 A DC micro-ohm contact resistance meter for MV, HV and EHV equipment, with printer, 1000-record memory and mains or battery operation.
-
DC Trace DC Earth Fault Locator
Portable DC earth fault locator with signal generator and receiver that finds faults in live substation DC systems online, detecting up to 1 MΩ.
-
DEC R High Voltage Decade Resistance Box
High-resistance, high-voltage decade resistance box for calibrating insulation testers, covering 1 kΩ to 1 TΩ at up to 5 kV, in 3, 4, 6 or 9 decades.